YZF-R6/R1/R7 LED Tail Brake Lights Turn Signal Integrated Compatible with YZF-R6 2017-2022,YZF-R1/R1S/R1M 2015-2022,YZF-R7 2022-2023 Motorcycle Accessories (Smoke)

Fitment:Compatible with: YZF R6 2017-2022,YZF R1 R1S R1M 2015-2022,YZF R7 2022-2023 *Please confirm compatibility before ordering-Material:ABS plastic + PC -High quality,Long-lasting,Super bright -Simple to fit the tail,brake,and turning sighals (left & right) are all integrated in one. -Available color for lens:Smoke/Clear/Red -Light color:Red/Yellow -Driving light power: 12V/0.36W -Brake light power: 12V/1.8W -Turn signal power: 12V/1.08W -Easy to install;Without instructions. -If the light work abnormaly,you need to add a resistance. Wiring Diagram applicable to most bikes: Black Wire(Negative), Green Wire(Brake) Red Wire(Running Light) 1. Connect one end of the resistor to the ground wire on your turn signal harness from your bike. 2. Connect the other end of the resistor to both the YELLOW wire from our taillight and the positive turn signal wire from your turn signal harness from your bike. 3. Repeat the same process for the other side. To use the red connectors, place one wire inside along one channel, place another wire inside along the other channel. Push down the metal pin as it will make a small cut on each wire bridging the connectors. if you are using the resistors, place one end of the resistor in the middle of either channel along with the one wire.⚠️ IMPORTANT INSTALLATION NOTICE (PLEASE READ BEFORE PURCHASE):Do not install directly. Please test the wires with an external battery before installation to confirm the function of each wire.Improper installation may cause malfunction or damage. During installation, thread locker MUST be used on all screws to prevent loosening due to vibration while riding.This product is intended for users with basic motorcycle modification and wiring knowledge. If you are not experienced, professional installation is strongly recommended.

• ⚠️ IMPORTANT INSTALLATION NOTICE (PLEASE READ BEFORE PURCHASE): *Do not install directly. Please test the wires with an external battery before installation to confirm the function of each wire. *Improper installation may cause malfunction or damage. During installation, thread locker MUST be used on all screws to prevent loosening due to vibration while riding.
• *This product is intended for users with basic motorcycle modification and wiring knowledge. If you are not experienced, professional installation is strongly recommended.
• Compatible with: YZF R6 2017-2022,YZF R1 R1S R1M 2015-2022,YZF R7 2022-2023 *Please confirm compatibility before ordering
• -Material:ABS plastic + PC -High quality,Long-lasting,Super bright -Simple to fit the tail,brake,and turning sighals (left & right) are all integrated in one. -Available color for lens:Smoke -Light color:Red/Yellow
• -Driving light power: 12V/0.36W -Brake light power: 12V/1.8W -Turn signal power: 12V/1.08W -Easy to install;Without instructions. -If the light work abnormaly,you need to add a resistance. -Please Ensure This Part Fits Your Motorcycle Before You Place The Order.
• Simple Wiring & Direct InstallationStandard wiring: Black = negative, Green = brake, Red = running light.No instructions included; install easily with listing photos. Resistor & Connector GuideIf turn signals flash rapidly, install a resistor: connect one end to turn signal ground, the other to taillight yellow wire and turn signal positive. Use red quick connectors by inserting wires into channels and pressing the metal pin for stable connection.